This cable powers a rear light from the Bosch bike battery. The Bosch connector plugs into the system and bare red and black leads splice to the taillight.

This cable carries power and the on/off signal from the Bosch system to your taillight, so the rear light turns on with the bike and never needs its own charge. The Bosch connector plugs into the light port; the two bare wires splice to the light.

It is the taillight counterpart to the Bosch headlight cable. On a full system-light setup you run the headlight cable up front and this cable to the back, both drawing from the same drive unit.
Pick the 200 mm (7.9 in) cable when the taillight sits close to a junction or splitter. Pick the 1400 mm (55 in) cable to reach a rear-rack or seatstay-mounted light from the motor area. Buy the length that suits your routing, extra cable just adds to tuck away.
The red two-pin connector is Smart System (Gen 5 / BES3). The black connector is the older Classic-line / BES2 plug (Gen 1–4). Order by the connector your bike uses, not just by length, the plugs are not interchangeable.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Smart System and the prior generation do not interchange. Our Bosch reference is the same set of pages our service team works from.
Don’t see yours? Ask the team directly.
Use the 200 mm (7.9 in) cable when the taillight is close to a wiring junction, and the 1400 mm (55 in) cable to run all the way back to a rear-rack or seatstay light. When in doubt, the longer cable can be tucked or trimmed at the splice.
It depends on your motor generation. The red two-pin connector fits Smart System (Gen 5 / BES3) bikes; the black connector fits Classic-line and BES2 motors (Gen 1–4). Check which system your bike runs, or send us the model and we will confirm the right cable.
No. This is the connection cable only. It pairs with a Bosch-system-compatible rear light, which draws power from your eBike battery through this cable.
The Bosch connector plugs into the system light port and the two bare wires at the other end splice to the taillight, red is positive, black is negative. The light output and voltage are then enabled by an authorized Bosch dealer in diagnostic software.
No. A system light powered through this cable runs off your main eBike battery, so there is nothing extra to charge and the light comes on with the bike.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.