The screw-on plate and screws that hold a Bosch Smart System PowerTube battery in the frame, in horizontal or vertical to match your bike. It's the plate the battery seats against, sold separately from the lock-side and cable-side mounting kits, so it's the right part when a plate is cracked, stripped, or missing after a frame repair rather than the whole battery cradle.

This is the molded plate, plus its two screws, that the PowerTube battery locks into inside the frame. It is the part to order when a plate is cracked or stripped after a crash or a frame repair, not the whole battery and not a new cradle.

The kit comes in two orientations because PowerTube batteries load into the downtube two different ways. The plates are shaped differently and are not interchangeable, so order the one that matches how your battery sits.

Built for the current Bosch Smart System PowerTube. It does not fit eBike System 2 (the prior generation) or PowerPack batteries. We are an authorized Bosch service center, so if you are unsure of your generation, send us your bike and we will confirm before you buy.
A real Bosch PowerTube mounting plate, not a third-party substitute. The hardware that holds your battery should be the right part.
We are an authorized Bosch eBike service center. Unsure of your generation or which mount you need? Send us your bike and we will confirm before you order.
Smart System and the prior generation do not interchange. Our Bosch reference is the same set of pages our service team works from.
Don’t see yours? Ask the team directly.
Match the orientation to how the PowerTube battery sits in your frame. If the battery loads in along the line of the downtube it is horizontal; if it drops in across the tube it is vertical. The plate geometry differs between the two, so they are not interchangeable.
No. This plate kit is for the Bosch Smart System PowerTube only. eBike System 2 uses different mounting hardware. Tell us your bike and battery and we will confirm the correct part before you order.
No. The PowerTube mounting hardware is split into separate parts: this plate kit, the lock-side mounting kit, the cable-side mounting kit, and the frame base. This is the plate the battery seats against. If you are not sure which piece you need, email us with your bike and what failed and we will sort it.
Order the vertical plate kit on this page. For the horizontal version or if you are unsure which part you need, email us and we will get the right one out to you.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.