The internal harness that carries power and data between a Bosch PowerTube battery and the drive unit on Classic+ (BES2) e-bikes. The PowerTube sits sealed inside the downtube, so this cable is the link that gets current to the motor and lets the system talk to the battery; it ends in the keyed PowerTube battery connector on one side and the motor/controller plugs on the other.
Available in-store and by order. Ask us and we’ll have it ready.

A PowerTube battery is sealed into the downtube, so it can’t bolt straight to the motor the way an external PowerPack does. This harness is the run that carries current to the drive unit and the data line that lets the system read state-of-charge and faults.

It ships in five lengths (220, 310, 410, 820, 950 mm) because the distance from the battery bay to the motor changes with frame size and where the PowerTube seats. Too short won’t reach and too long won’t route cleanly inside the tube, so the right call is the length that matches your exact frame and battery position.
This is the older Classic+ (BES2) harness, identified by Bosch drive-unit codes BDU2XX and BDU3XX, covering Active Line, Active Line Plus, Performance Line, and Performance Line CX bikes from that generation. A Smart System (BES3) bike uses different wiring and a different connector, so this cable will not fit it.
The harness routes inside the frame and the PowerTube is keyed to the bike, so replacing it means opening the battery bay, threading the new cable through the downtube, and re-seating everything so the battery locks and reads correctly. We’re a Bosch service center; if you tell us the frame and motor, we’ll confirm the length and generation and handle the swap.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Smart System and the prior generation do not interchange. Our Bosch reference is the same set of pages our service team works from.
Don’t see yours? Ask the team directly.
It depends on your frame size and where the PowerTube battery seats; the run to the motor is longer on bigger frames and certain battery positions. The five lengths are 220, 310, 410, 820, and 950 mm. If you’re not sure, send us your frame and motor and we’ll match the right one rather than have you guess.
No. This is the Classic+ (BES2) harness for drive-unit codes BDU2XX and BDU3XX, Active Line, Active Line Plus, Performance Line, and Performance Line CX bikes of that generation. Smart System (BES3) bikes use different wiring and connectors and need a different cable.
It routes inside the downtube and the battery is keyed to the bike, so it’s an authorized-dealer service rather than a quick clip-in swap. We’re a Bosch service center and can do it; if you’re comfortable opening the battery bay yourself, confirm the length and generation first.
A damaged PowerTube cable usually shows up as a battery the bike won’t recognize, intermittent power, or fault codes after a battery-bay or motor service where the harness may have been pinched or cut. We can diagnose it before you order a replacement.
Yes; it’s the Bosch PowerTube cable (Bosch model E2161). Because the system reads the battery over this line, we use the genuine harness rather than a substitute.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.