This Smart System cable powers a wired accessory such as a light, tracker, or ABS component from the bike battery. It has a Bosch connector at one end and bare red and black leads at the other, so installation requires a weatherproof splice.
Available in-store and by order. Ask us and we’ll have it ready.

Powers a wired accessory, ABS, a GPS tracker, an extra light, or an eShift unit, straight off the Smart System battery, so you skip a separate cell and charger.

HPP (yellow) and LPP (green) both supply 1 amp continuous; the HPP handles a higher short-term peak. Put a draw-heavy device on the yellow port, a light load on the green.

200 mm stays right at the port for a nearby device; 1,400 mm runs along the frame to the bars or rear rack. Measure the run before you order.
Works on Bosch Smart System bikes (model year 2022 and later, the eBike Flow generation). It will not connect to an older System 2 / pre-2022 Bosch drive, those use different cabling.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
We diagnose and service the Bosch Smart System in-house, so we can spec the right port and length for your bike.
OE Smart System accessory cable, not an aftermarket substitute.
Smart System and the prior generation do not interchange. Our Bosch reference is the same set of pages our service team works from.
Don’t see yours? Ask the team directly.
A wired accessory drawing from the Bosch Smart System battery, most commonly Bosch ABS, a GPS tracker, a supplemental light, or an eShift unit. It carries power only; it isn't a data or shifting cable on its own.
HPP is the high power port (yellow connector) and LPP is the low power port (green connector). Both deliver 1 amp continuous. The HPP tolerates a higher short-term peak load, so heavier-draw accessories go on the yellow port and light loads on the green.
It depends on routing. Choose 200 mm when the accessory sits right next to the port; choose 1,400 mm to run the cable along the frame to the handlebars or rear rack. Measure the path before ordering.
Only the Bosch Smart System (model year 2022 and later, the eBike Flow generation). It won't connect to an older System 2 / pre-2022 Bosch drive. Not sure which you have? Tell us the bike and model year and we'll confirm.
The bike end is a Bosch port connector, but the accessory end is bare tinned leads (red and black), you wire it to the device with a solder or crimp and weatherproof the joint. We can terminate it for you if you'd rather not.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.