The wiring harness that links a rear rack-mounted Bosch PowerPack to a bike's eShift automatic transmission. eShift is Bosch's automated electronic shifting; the system shifts the internally geared hub for you based on your pedaling cadence and speed, so there are no shift levers to think about.
Available in-store and by order. Ask us and we’ll have it ready.

On a rack-battery Bosch bike, the PowerPack sits over the rear wheel rather than in the downtube. This Y-cable splits the connection so the battery, motor, and eShift gearbox stay linked, without it, the automatic transmission loses its signal and the bike falls back to a fixed gear.

eShift shifts the internally geared hub for you based on cadence and speed, so there are no levers to flick. This harness carries the data and power that make that automatic shifting happen.
This is a replacement and rebuild cable, not an upgrade. Reach for it when an eShift bike has lost connection to its gearbox, the original harness is damaged, or a shop is reassembling a rack-battery system.
This is a BES2 Classic Line cable for bikes on the Intuvia and Nyon (1st gen) displays. Smart System (BES3) bikes use a different connector and protocol and need their own harness; send us your model and we will confirm the generation before you order.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Smart System and the prior generation do not interchange. Our Bosch reference is the same set of pages our service team works from.
Don’t see yours? Ask the team directly.
It is the wiring harness that links a rear rack-mounted Bosch PowerPack to the bike's eShift automatic transmission, so the battery, motor, and gearbox all stay connected. On rack-battery bikes the connection has to split to reach the eShift module; that split is this Y-cable.
BES2 Classic Line bikes, the pre-Smart System generation that runs Intuvia or Nyon (1st gen) displays, with an eShift automatic transmission (NuVinci/enviolo, Shimano Di2, or SRAM). It does not fit Smart System (BES3) bikes, which use a different connector and harness.
It depends on your frame's cable routing from the rack battery to the eShift module. Pick the length that reaches cleanly without excess slack or tension. If you are unsure, email us your bike model and we will tell you which one fits.
No. It is a connection cable for bikes that already have an eShift automatic transmission and a rack-mounted battery. It does not add automatic shifting to a bike that did not come with it.
It is a plug-in harness, but routing it correctly and confirming the right length and generation matters. We are an authorized Bosch service center; if you would rather have it done right or you are unsure of the part, send us your model and we will sort it out.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.