The Bosch direct-mount chainring is the genuine front ring for Gen 2 (BES2) Bosch mid-drive motors, sold in 15-, 18-, and 20-tooth sizes. It bolts straight onto the motor's output spindle, no spider or bolt circle to match.

The chainring is the drivetrain part mounted on the motor itself, so it wears with every mile. On Bosch Gen 2 motors the teeth eventually hook into a shark-fin profile that lets the chain skip or ride up under power.

Fewer teeth (15t) lower the overall ratio for easier climbing, heavy loads, and internally geared hubs; more teeth (20t) raise it for a taller, faster feel on flat roads; 18t is the middle. Changing the front ring is the simplest way to retune a Bosch Gen 2 bike’s gearing without swapping the cassette.

This is the BDU2XX direct-mount ring for Active Line, Performance Line, and Performance Line CX motors built roughly 2014–2020. It does not fit Bosch’s Gen 3 (BDU3XX), Gen 4 (BDU4XX) or Smart System drives, which run a full-size chainring on a spider.
Propel is a Bosch service center and we change these rings on Gen 2 bikes regularly. If the part is the right size but the chain still skips, the cause is often a worn chain or cog rather than the ring; we can diagnose the whole drivetrain so you only replace what actually needs it.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Smart System and the prior generation do not interchange. Our Bosch reference is the same set of pages our service team works from.
Don’t see yours? Ask the team directly.
Bosch Gen 2 (BES2) drive units, Active Line, Performance Line, and Performance Line CX, with drive-unit codes in the BDU2XX family, fitted to bikes built roughly between 2014 and 2020. It does not fit Gen 3 (BDU3XX), Gen 4 (BDU4XX) or Smart System motors.
Gen 2 bikes use the older Bosch displays and the eBike Connect app (Intuvia, Purion, original Nyon or Kiox). If your bike uses the Kiox 300, a System Controller, the Smartphone Grip, or the eBike Flow app, it is a Smart System (BES3) and this ring will not fit. When in doubt, send us your bike model or a photo of the current chainring and we’ll confirm.
Match what came on the bike unless you want to change the feel. A smaller ring (15t) lowers the gearing for steeper hills, heavier loads, and internally geared hubs; a larger ring (20t) raises it for a taller, faster ratio on flat riding; 18t sits in between. The chainring is a single fixed ring, so the tooth count sets the whole bike’s ratio with the rear gearing.
On Bosch Gen 2 motors the chainring teeth wear into a hooked, shark-fin shape that lets the chain climb or skip under power, especially when you pedal hard from a stop. A worn chain or rear cog can do the same thing. Replacing the ring fixes a worn ring; if the chain and cog are also worn, replace them together so the new ring doesn’t wear quickly against an old chain.
Yes, with the right tool. The ring is held by a lockring on the motor’s output spindle, so you remove the spider cover, undo the lockring, swap the ring, and torque it back. If you’re not set up for it or want the chain and cog checked at the same time, we can do the swap and a drivetrain check in the shop.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.