What should I do if water gets into the battery mount?
What to do if water gets into your e-bike battery mount: the contacts are built to drain and dry, so keep the mount clean and use contact grease if needed.
Don't worry. The battery mount is designed to shed water, the contacts can drain and dry on their own, and the contact surfaces have a coating that protects them against corrosion and wear. Riding in the rain is fine.
To keep it working that way:
- Keep the mount and plug area clean. Grit and road grime cause a lot more trouble than a bit of rainwater, so wipe the mount and the battery contacts now and then.
- Let it drain and dry. If water has pooled, take the battery off, tip the bike so the mount can drain, and let the contacts air-dry before you refit the pack.
- Don't use a pressure washer on it. High-pressure water can force moisture past the seals, and a gentle rinse and a wipe are all it needs.
- A little contact grease helps. Terminal grease or a technical petroleum jelly can be applied to the contacts if needed to hold off corrosion.
If the battery or system starts acting up after a soaking, like throwing an error or not charging, stop using it and bring the bike in so we can check the contacts and connectors.
More in Motors & batteries
Still stuck, or is this about your own bike? The service team answers these all day.