Gates Belt Drive handling dos and don’ts
Handle your Gates carbon belt right: never pry it with a screwdriver, twist it, kink it, or over-tension it, so it keeps running quiet for years.
A Gates carbon belt is tough in daily use, and a few simple handling rules will keep it that way. The belt is a continuous loop reinforced with carbon cords, and it goes on and off through a split in the frame, not by breaking a link like a chain.
Don't:
- Pry the belt over a sprocket or frame with a screwdriver or lever. That can nick or crack the internal cords.
- Twist, fold, or kink the belt tightly, or use it as a handle to lift or hold the bike.
- Over-tension it. Too tight wears the hub and bottom-bracket bearings; too loose lets it skip.
Do:
- Slip the belt on and off by hand through the frame's belt split.
- Keep it tracking centered on both sprockets.
- Set tension to Gates spec with the Gates Carbon Drive app or a Gates gauge.
The videos below show the right way to handle it.
More in Service & maintenance
Still stuck, or is this about your own bike? The service team answers these all day.