A 200mm (about 7.9 in) adapter cable that connects a Supernova eBike headlight to a 2nd-generation Bosch drive unit. If you're running Supernova lighting on a Bosch system, this is the link that gets the light powered off the motor.

This is a short 150 mm jumper that taps your Bosch motor's light circuit to power a Supernova rear light. The taillight runs off the bike's main battery, so there's nothing extra to charge and no AAs to swap.
A Bosch plug goes to the motor side; the open ends connect to your taillight with the two crimp connectors in the box. No soldering iron needed, just a pair of pliers to seat the crimps. The cable is PVC-free.
This fits the older classic Bosch drive units with the round connectors, generations one through four. It is not the Smart System connector. If you're on a newer Smart System bike the plug won't match, so check your motor with us before ordering.
Reach for this when you're adding or replacing a Supernova taillight on a Gen 1-4 Bosch e-bike and the light sits near the motor's wiring exit. At 150 mm it's the short version, and it's the only length in this part.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
It's made for the classic round-connector Bosch drive units, Gen 1 through Gen 4 (BDU2xx/3xx/4xx era). If you have a newer Bosch Smart System bike, check the connector type first, since that system uses different plugs.
No soldering required. It includes 3M Scotchlok connectors, so you crimp the cable into your rear light's wire. A pair of pliers to seat the connectors is all you need.
The 150mm rear version is the short jumper for a taillight close to the motor's wiring. The other listing is the same cable family in a different length or routing. Match the length to where your light mounts.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.