A replacement rear sprocket for Shimano Nexus and Alfine internal-gear hubs, sold by tooth count to retune your gearing. On an internal-gear-hub bike there's no derailleur and no cassette.
Available in-store and by order. Ask us and we’ll have it ready.

Internal-gear-hub bikes run a single rear cog instead of a cassette. Change the cog and every gear shifts up or down together, with no derailleur tuning and no new wheel. Drop to a 16T for more top-end on flats, or go to a 22-23T to gear down for hills and cargo.
Chains stretch with use and slowly hook the sprocket teeth, which shows up as skipping or noisy, sloppy shifting. A fresh cog (ideally with a new chain) brings the drivetrain back to quiet and crisp.
Flat city commute and you want more speed before you spin out? A smaller cog. Hilly routes, a heavy cargo setup, or you just want an easier spin? A larger cog. We'll help you pick the tooth count off your hub model and how you ride.
The 3-spline interface covers Nexus 3/7/8 and Alfine 8/11 hubs, the low-maintenance internal-gear setups on bikes like the Gazelle Medeo C8 and older Nexus commuters. The same spline also fits Sturmey-Archer and SRAM/Sachs IGH drivers.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
It depends on your hub and your terrain. A smaller cog (16T) gears the bike taller for more speed on flats; a larger cog (22-23T) gears it down for hills and heavier loads. If you're replacing a worn one, match the tooth count that's on the bike now unless you want to change the feel. Tell us your hub model (Nexus 8, Alfine, etc.) and how you ride and we'll size it.
It fits Shimano Nexus and Alfine internal-gear hubs, which use a 3-spline rear cog held on by a snap ring. The same spline also fits Sturmey-Archer and SRAM/Sachs IGH hubs. It does not fit derailleur (cassette) drivetrains. If you're unsure, send us your hub model or bring the bike in.
A 1/8" single-speed chain (1/2 x 1/8"), the standard chain for internal-gear-hub bikes. This is also why 16T is the practical smallest cog; anything smaller interferes with the 1/8" chain.
Usually yes. A worn cog almost always means a worn chain, and putting a new chain on a hooked cog (or a new cog behind a stretched chain) brings the wear right back. We replace them as a pair so the drivetrain runs quiet and shifts cleanly.
Either. These are sold as a single sprocket by tooth count. We stock them and can install one as part of a tune-up; internal-gear hubs need the wheel pulled and the snap ring reseated, so it's a quick job for our mechanics. Email us to order or book a service.
We know the part numbers, the tools and what changed between generations. Tell us the bike and we will confirm the part before you order.
Book a service visit and we install the part while the bike is with us. No tools, no greasy fingers, no botched brake bleed.
Sometimes the part you came for is not the problem. If the cassette is fine and the chain is the real culprit, we say so before you buy.