A black left-side hydraulic disc brake lever from Shimano's Acera BL-MT401 line, a mineral-oil lever meant as a direct spare or replacement on bikes already running a matching Shimano hydraulic disc setup. It's the left lever only, so it pairs with the corresponding caliper and hose on whichever side your bike routes the left lever to.
Both levers are the same hydraulic master cylinder; the difference is which side of the handlebar they're built for and which caliper they route to. On most setups the left lever runs the front brake and the right runs the rear, but that depends on how your bike was plumbed.
This lever is designed to work with Shimano's BR-MT400, MT410, and MT420 hydraulic calipers using the correct mineral-oil hose (SM-BH59 or SM-BH90 depending on caliper). It is not a fit for SRAM brakes (different fluid and bleed standard) or for older Shimano two-piece-hose systems without the right hose kit.
Like all Shimano hydraulic brakes, the MT401 uses Shimano mineral oil, never DOT fluid, which will destroy the seals. After install the system needs a proper bleed with the matching bleed cup and funnel.
This is a bare lever. Swapping it means cutting and re-connecting the hose (or running a new one), fitting a barbed insert and olive, and bleeding the brake. If you're not set up to bleed Shimano brakes, it's a job worth handing to a shop.
Pick the side you actually need: "left" and "right" refer to which side of the handlebar the lever mounts and which caliper it feeds. It's lever-only here, so no caliper, hose, or oil comes in the box.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
Buy the lever for the side of the handlebar you're replacing. Left and right are mirror-built and route to different calipers. Convention in the US is left lever = front brake, right lever = rear, but check how your bike is actually set up before ordering, since some bikes (and most setups outside the US) reverse it.
No. This SKU is the brake lever only. It's meant as a replacement for a damaged lever on a bike that already has a matching Shimano MT400-series caliper. You'll reuse your existing hose or buy a new hose kit, plus mineral oil to bleed.
No. The MT401 is a Shimano mineral-oil system and isn't compatible with SRAM (DOT fluid) or other brands' hydraulic brakes. It only pairs with Shimano hydraulic calipers using the correct mineral-oil hose.
We know the part numbers, the tools and what changed between generations. Tell us the bike and we will confirm the part before you order.
Book a service visit and we install the part while the bike is with us. No tools, no greasy fingers, no botched brake bleed.
Sometimes the part you came for is not the problem. If the cassette is fine and the chain is the real culprit, we say so before you buy.