The A12 reduction sleeve that steps a 12 mm thru-axle dropout down to the 7 mm bolt that holds a Rohloff A12 hub. It goes on the disc side of every A12 setup and the sprocket side of Syntace X12 V1 and Shimano frames, and S versions are measured lengths, so replace like for like.

Instead of a thru-axle, two M7 bolts clamp the A12 hub. The sleeve fills the frame's 12 mm hole so the bolt is centered and the dropout is clamped between sleeve and axle plate.
Rohloff wants a 0.5–1 mm gap between sleeve and axle plate. Too short or too long and the bolt can't clamp safely, which is why S lengths are chosen from a dropout measurement.
Rohloff says trailer hitches that mount on the 12 mm thru-axle must not be used with an A12 hub; the extra thickness stops the bolt from engaging enough thread.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
Whatever your hub came with. The standard 8592 covers the standard positions; the S versions are special lengths chosen from your frame's dropout measurement. Check the label on your hardware bag or send us a photo.
Every A12 setup uses it on the disc side. On the sprocket side it goes in Syntace X12 V1 and Shimano E-Thru frames; DT/Maxle and Syntace X12 V2 frames use a threaded sleeve there.
The M7 securing bolt and a fresh pair of Nord-lock washers (replace them every fourth use), plus the spacer or conical spacer your frame uses.
Rohloff requires a dropout measurement by a qualified shop before an A12 hub is fitted. Email us and we'll point you to the right next step.
We know the part numbers, the tools and what changed between generations. Tell us the bike and we will confirm the part before you order.
Book a service visit and we install the part while the bike is with us. No tools, no greasy fingers, no botched brake bleed.
Sometimes the part you came for is not the problem. If the cassette is fine and the chain is the real culprit, we say so before you buy.