Converts a rim-brake Rohloff Speedhub to the disc-brake interface so you can move your 14-speed hub into a disc-brake frame. This is the hub-side conversion hardware, not a brake set: a disc-brake hub cap with Rohloff's 4-bolt rotor mount (IS1999), the matching axle plate for your axle type (CC quick-release, TS threaded, or A12 thru-axle), and the external gear mechanism the disc version requires.
Available in-store and by order. Ask us and we’ll have it ready.

If you own a rim-brake Speedhub and your next frame uses disc brakes, you don't have to buy a second hub. This kit moves the disc-brake interface onto your existing 14-speed hub. The gear internals (526% range, even 13.6% steps) carry over unchanged.

Rohloff hubs use their own 4-bolt rotor mount (65 mm bolt circle, 52 mm center, IS1999), not the 6-bolt or Centerlock pattern. That's why a DB hub cap and a Rohloff-specific rotor are required rather than a generic disc kit.
Pick the axle plate that matches your frame: CC for quick-release, TS for threaded solid axle, A12 for a 12 mm thru-axle. The frame also needs IS1999 disc mounts. Tell us the frame and we'll confirm the right combination before ordering.
A rear disc rotor can't clear the internal twist-shift mechanism, so a disc conversion always runs the external gear mech, cable on a mechanical bike or E-14 on a Bosch e-bike. If you're on a twist shifter today, that changes too.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
No. It's the hub-side disc conversion: a disc-brake hub cap with Rohloff's 4-bolt mount, the matching axle plate, and the external gear mechanism. The brake rotor is a separate Rohloff part (160–220 mm), and you use your own calipers and levers.
It depends on your frame. CC is for quick-release, TS for a threaded solid axle, and A12 for a 12 mm thru-axle. Send us your frame or current setup and we'll confirm the right one before ordering.
Yes, the frame must have disc-brake mounts to the IS1999 international standard (or a Direct Post Mount with the right adapter). It also needs the correct O.L.D. rear spacing for your hub width.
A rear disc rotor would clash with Rohloff's internal twist-shift mechanism, so every disc-brake Speedhub runs the external gear mech instead, cable-shifted on a mechanical bike or the E-14 unit on a Bosch e-bike.
The actual hub-to-disc conversion is carried out by Rohloff's service department, not as a home install. We coordinate it: we spec the kit for your axle standard, handle the hub, and set up the external mech or E-14.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.