Rohloff's compact DH chain tensioner for the inset chainline on wide 148/190/197 mm cargo and fatbike Speedhub builds. A Speedhub run on a single rear sprocket still needs something to take up chain slack as the wheel moves, and on a chain drive that job falls to the tensioner.
We do not have a live stock feed for this one. Ask us and we check with the brand or our distributor, then confirm the price and the date with you before anything is charged.

A chain-driven Speedhub runs one rear sprocket, so a tensioner takes up the slack and holds chain wrap. The DH Shorty uses a shortened, anti-rotation swing arm that keeps the upper pulley close to the sprocket, so the chain stays put over rough ground and hard pedaling instead of skipping or dropping.
This is the offset version for XXL-width builds: fatbikes and some wide cargo frames where the rear sprocket sits further inboard than a standard 135/142 mm hub. The 10 mm and 15 mm options move the tensioner inboard to match that chainline.
A Gates belt build uses fixed dropouts and no tensioner, so this part is for chain drives. It bolts to the derailleur hanger and includes spacer washers to fine-tune the chainline.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
Both are the same DH Shorty tensioner; the number is how far inboard the pulleys are offset to meet the rear sprocket. Wide 148/190/197 mm hubs push the chainline inboard, and you pick the offset that lines the tensioner up with your sprocket. If you are not sure which your frame needs, email us with the bike and hub width.
It is made specifically for chain-driven Speedhub builds on wide 148, 190, or 197 mm over-locknut (XXL) frames, such as fatbikes and some wide cargo bikes. A standard 135/142 mm frame uses the regular Rohloff tensioner instead, and a Gates belt build does not use a tensioner at all.
No. A belt-drive Speedhub bike uses fixed dropouts and keeps belt tension without a tensioner, so there is nothing for this part to do. It is only for chain-driven setups.
It bolts to the frame’s derailleur hanger with a 5 mm hex at 8 Nm (70 in-lb), and includes a short and long frame bolt plus aluminum and steel spacer washers so you can set the exact chainline. It is a twin-pulley arm with a 10-link span capacity.
Yes. We service Rohloff drivetrains in the Brooklyn shop, including chainline setup and tensioner fitting. Email us to order or to confirm the right offset for your frame.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.