The threaded sleeve that lets a Rohloff Speedhub A12 bolt into a 12 mm thru-axle frame. It sits in the frame's dropout and steps the 12 mm hole down so the hub's M7 securing bolt threads through it and into the axle.
Available in-store and by order. Ask us and we’ll have it ready.

The A12 axle is hollow and tapped for an M7x1 bolt, but a thru-axle frame's dropout is bored for 12 mm. This sleeve threads into the dropout and reduces the bore so the M7 bolt passes through it and into the axle, clamping the hub square to the frame.

The sleeve is sold by thread pitch, M12x1 (8598), M12x1.5 (8599), or M12x1.75 (8593), because it has to match the threads cut into your dropout. There are also extended "S" versions for thicker dropouts.

This is the right-hand (sprocket-side) sleeve. The non-drive side uses its own left-hand sleeve and spacer, so a full A12 frame conversion needs the matching parts on both sides. If you're replacing a lost or damaged sleeve, match the side and pitch to what's already on the bike.

You reach for this when fitting a Speedhub A12 into a 12 mm thru-axle frame, or replacing a worn or missing sleeve on a bike already set up that way. On most Propel Rohloff builds the hub is bolted up at the factory or in our shop, so this is a service and conversion part rather than something you add to a finished bike.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
It threads into your frame’s 12 mm thru-axle dropout and reduces the bore so the Rohloff Speedhub’s M7 axle bolt can pass through it and thread into the hollow A12 axle. That bolt is what clamps the hub to the frame.
It has to match the thread cut into your frame’s dropout: M12x1 is Rohloff 8598, M12x1.5 is 8599, M12x1.75 is 8593. There are also extended "S" versions for thicker dropouts. Measure the dropout or have a shop check it before ordering, the wrong pitch will not thread in. If you’re unsure, send us the frame details and we’ll match it.
No. A full A12 fitment uses a right-hand (sprocket-side) sleeve plus a separate left-hand sleeve and spacer on the non-drive side. This listing is the right-hand sleeve only. For a complete conversion you’ll need the matching non-drive parts too.
No. The M7x1 securing bolt ships with the Speedhub A12 hub itself, not with this sleeve. This is the threaded sleeve only.
This 8599/8593-family sleeve threads directly into a tapped 12 mm dropout. The 8592-series thru-axle sleeve is for frames that use a separate thru-axle insert. They are not interchangeable, pick the one that matches how your frame holds the axle.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.