A 180mm Center Lock disc rotor from Magura's MDR-C line, packaged with the lock ring you need for thru-axle hubs. It's the spare to grab when your Center Lock front or rear rotor is worn or warped and your bike runs 180mm.

The MDR-C is a one-piece martensitic chrome-steel disc, 2mm thick, with more mass and a wider heat window than a standard rotor. On a heavy e-bike, cargo bike, or loaded tourer, that extra mass is what keeps the brake from fading on a long, weighted descent.
A stiffening ring adds lateral rigidity to the disc, which cuts the vibration and brake noise you get when a thinner rotor flexes under hard stops. The result is a more consistent bite, lever pull after lever pull.
Buy it when your current disc is warped, glazed, or worn down. Magura calls 1.8mm the wear limit, so once a rotor measures that thin it's done and the MDR-C is a direct, heavier-duty replacement on a Magura-equipped bike.
It comes in 6-bolt (160/180/203/220mm) and Center Lock (160/180/203mm, lockring included for quick-release axles). Pick the interface your hub already uses and the diameter your brake and frame or fork are set up for.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
It depends on your hubs, not your brake. If your hub has six threaded holes on the flange, you need the 6-bolt rotor (44mm BCD). If your hub has a single splined collar, you need the Center Lock version. The Center Lock rotors listed here come with a lockring sized for quick-release (skewer) axles; thru-axle hubs use a different internal-spline lockring, so check your axle type too.
Replace the same diameter you're running now, 160, 180, or 203 mm. Rotor size is matched to your caliper adapter and frame/fork clearance, so swapping to a different size usually means changing the adapter and confirming your frame or fork is rated for it. When in doubt, match the marking on your old rotor.
It's optimized for e-bike braking with its 2mm thickness and heat handling, but it bolts up to any standard 6-bolt or Center Lock hub. It's a reasonable upgrade for heavier loads or hard braking on a non-assist bike too.
We know the part numbers, the tools and what changed between generations. Tell us the bike and we will confirm the part before you order.
Book a service visit and we install the part while the bike is with us. No tools, no greasy fingers, no botched brake bleed.
Sometimes the part you came for is not the problem. If the cassette is fine and the chain is the real culprit, we say so before you buy.