A replacement lever blade for the Magura MT4e hydraulic disc brake, a 3-finger blade with a ball end and the HiGo closer for the brake's e-bike motor cutoff. This is the spare you want when an MT4e blade gets bent, snapped, or scuffed in a tip-over, rather than replacing the whole lever assembly.

This is the replacement lever blade for Magura's MT4e e-bike brake. When the blade gets bent or cracked, or the integrated cut-off switch stops working, you swap the blade instead of buying the entire brake.
On an e-bike, the brake lever does double duty: pulling it cuts motor power and triggers the brake light through the integrated HIGO connector. That's why a damaged or failed blade is worth fixing right away, and why this is a wired service part rather than a plain piece of aluminum.
The SMART and CLOSER versions differ only in their HIGO wiring, and they don't cross over. Pick SMART if your bike runs the Riese & Müller system; pick CLOSER (the standard normally-open type) for most other e-bikes.
The MT4e CLOSER blade is Magura part 2700836. If you're not sure which switch type your bike uses, match that number or send us a photo and we'll confirm before you order.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
It comes down to your bike's wiring. SMART is the version specified for Riese & Müller bikes. CLOSER is the standard normally-open HIGO switch used on many other e-bikes. The switch type is not standardized across brands, so match it to what your bike originally shipped with, if you can read the part off the old lever or your bike's spec sheet, do that, or check with us.
Yes. Magura uses the same 3-finger lever blade across the MT4e and MT5e e-bike brakes, so this blade works on both as long as the HIGO switch type (SMART or CLOSER) matches your system.
No. This is the lever blade for the master cylinder only. The hydraulic hose, the caliper, and the handlebar clamp are separate. If your whole brake is shot rather than just the blade, you'd want the full master-cylinder assembly instead, reach out and we'll point you to the right part.
We know the part numbers, the tools and what changed between generations. Tell us the bike and we will confirm the part before you order.
Book a service visit and we install the part while the bike is with us. No tools, no greasy fingers, no botched brake bleed.
Sometimes the part you came for is not the problem. If the cassette is fine and the chain is the real culprit, we say so before you buy.