Kinekt's seatpost gives your saddle 1.4 in (35 mm) of coil-sprung parallelogram travel, tuned to your weight by swappable springs. Fit comes first: match your seat tube diameter, leave about 4 in (10 cm) between the frame clamp and saddle rails, and pick LR for riders 80–180 lb or XR for 80–320 lb, which Kinekt says e-bike riders 150 lb and up should choose.

A four-bar linkage lets the saddle drop through up to 1.4 in (35 mm) of travel on two coil springs, so bumps, cracked pavement and expansion joints reach the post before they reach you.

Each post ships with springs installed and spares in the box. Kinekt's chart pairs an upper and lower spring with a weight range, with a separate column for city and e-bike riding, where more of your weight sits on the saddle.

Your seat tube diameter (printed near the bottom of your current post), the space between the frame's clamp and your saddle rails (Kinekt asks for about 4 in, or 10 cm), and your saddle's rail width, which can't be more than 36 mm.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
Pull your current seatpost and read the size printed near the bottom, like 27.2 or 31.6. It has to match your seat tube exactly. For other round sizes, Kinekt makes shims, so email us your number.
Go by your weight. LR covers riders 80–180 lb and XR covers 80–320 lb. On an e-bike, Kinekt's own rule is XR if you weigh 150 lb or more, because upright riding puts more of your weight on the saddle.
It needs a round seat tube and about 4 in (10 cm) of room between the frame's seatpost clamp and your saddle rails, or about 3.1 in (8 cm) for riders under 110 lb. If your saddle sits low on a small frame, measure that gap first.
Kinekt fits standard two-rail saddles with rails up to 36 mm wide.
Kinekt says to install it about 1 cm higher than a regular post to allow for sag, then tighten the preload until the saddle no longer rises when you get off, and fine-tune from there.
Tell us the bike you ride; we’ll confirm the accessory works with your specific frame, motor, and mounting points before it ships.
What is on our shelves is ready to pick up or ship. If something needs to be ordered, we tell you up front, not after you pay.
Shop install, walk-in service, or a remote walkthrough, whatever it takes to get the accessory working on your bike.