A replacement drive-side wiring harness for enviolo's electronic/Automatiq shifting system on ebikes; it's the cable that carries shift signals and power to the rear CVT hub. It's an optional spare and a brand-specific fit, so the right part depends on your exact bike, model year, and which enviolo electronic setup it runs.

This is the wire harness that runs to the drive (right) side of an enviolo electronic shifting setup, such as Automatiq. It carries the shift commands to the CVT hub so the system can trim your gear ratio.
enviolo electronic harnesses vary by bike platform, model year, and connector layout. Match the part to your exact setup rather than by name alone; when in doubt, we'll verify the right one for your bike.
It fits ebikes running enviolo's electronic/Automatiq shifting, but the correct harness depends on your specific bike, model year, and connector layout. Send us your bike make, model, and year and we'll confirm the right part before you order.
It's the drive-side wiring harness for an electronic enviolo CVT hub system. It connects the shifting electronics to the rear hub so the system can change gear ratio. It's listed as an optional/replacement part.
The harness itself is a wiring part, not the hub. Note that enviolo hubs themselves are usually wheel builds rather than drop-in swaps. If your repair also involves the hub or wheel, talk to us first so we can scope the full job.
Order it, ask us about fit, or book an install at the Brooklyn shop.