A bare enviolo CVP Heavy Duty rear hub, the stepless, no-shift-points CVT hub tuned for high-torque e-cargo use, in the 40t sprocket spline, 36-hole, 148mm Boost, disc-brake configuration. This is a wheel-build component, not a finished wheel: it ships as the hub only and needs lacing into a rim before it goes on a bike.

This is enviolo's CVP hub (continuously variable planetary), a stepless internal gear hub that gives you one smooth 380% range instead of fixed gears and shift clicks. The gears live sealed inside the rear wheel, so there's no derailleur hanging out in the weather to bend or wear.

This is the Heavy Duty version, rated for the torque and higher vehicle weight of e-bikes and cargo bikes rather than a lightweight city build. That's the grade you want under a mid-drive motor or a loaded cargo deck.

We sell and service these, and this is the part to reach for when a wheel is damaged or you're respacing an existing enviolo build. One honest note up front: this is the hub shell only.
Match the hub to your wheel and frame before you order. It comes in 32-hole and 36-hole drillings to suit your rim and lacing, and in a 135mm bolt-on axle or a modular axle for 142/148mm thru-axles, including a 148mm boost option, to match your dropouts.
Specs come from the maker and can change. If one of these numbers matters to you, ask us and we’ll check the exact item.
Don’t see yours? Ask the team directly.
They share the same Heavy Duty CVP hub and 40t spline driver. The choice is spoke count and axle width: 32-hole or 36-hole for your wheel build, and standard internally geared spacing versus the 148mm boost version for newer frames. Match the drilling to your rim and the width to your frame's dropouts.
The Heavy Duty grade is the one built for e-bike torque and cargo loads, so yes in principle, but fitment comes down to your frame's dropout spacing (which is why the 148mm option exists), disc standard, and the shifting interface your bike uses. Tell us the bike and we'll confirm before you order.
No. It's the hub shell with the 40t spline driver and a 6-bolt disc mount. You still need a CVP shifting interface, manual or AUTOMATiQ electronic, and a 40t-spline sprocket, plus spokes and a rim if you're building a fresh wheel. We can quote the matching parts so it ends up as a working drive.
We know the part numbers, the tools and what changed between generations. Tell us the bike and we will confirm the part before you order.
Book a service visit and we install the part while the bike is with us. No tools, no greasy fingers, no botched brake bleed.
Sometimes the part you came for is not the problem. If the cassette is fine and the chain is the real culprit, we say so before you buy.